![]() Routers R2 and R3 are belonging to transit area that way need to add commands on these routers. We create virtual links when some OSPF area is not physically connected with backbone area (Area 0). The area through which you configure the virtual link is known as a transit area. ![]() You need to make the virtual link on R2 & R3. Also in exam configuration i shall removes this area 54 virtual-link 4.4.4.4 command from R3 so that all routers can communicate with each other. ![]() R1(config-if)# ipv6 address FEC0:11::1/64įollow virtual-link configuration are wrong i have added these because in real exam you will find such wrong configuration and you need to removes these and need to configure R2 & R3 for virtual-link. Since i have simulate this lab in GNS3 for exam's practice that way first i have configured lab with wrong configuration as you will find in real exam in GSN3 configuration section and in Real exam section i correct all incorrect configurations and add with right configuration.Ĭreate this lab in GNS3 with following configuration, after these configurations you can start real lab configuration as you need to complete in exam. you need to short out the wrong virtual-link configurations that you will find on R3 & R4 i.e.įirst remove these command and add the correct one. And need to configure all routers with correct virtual-link commands.ġ. This lab is for testing your OSPF virtual-link concepts. Note: To gain the maximum number of points you must remove all incorrect or unneeded configuration statements related to this issue. Use the show ip route command on R3 to view its routing table You need to configure route summarization on R4 so that R3 has only 2 subnets of 10.0.0.0 network. R3(config-router)# eigrp stub R3(config-router)# end R3(config-router)# no eigrp stub receive-only To make the communication possible we need to replace this with eigrp stub command. ![]() Due to this command router R3 is not sharing any of its routes with any other router in that EIGRP 123. R4 & R3 are not communicating because of eigrp stub receive-only command in EIGRP Process 123. R2(config-if)# No shut R2(config-if)# end The success of pings from R4 to the R3 LAN interface proves that the fault has been corrected and the R3 IP routing table only contains two 10.0.0.0 subnets.Ĭreate the above lab with following configurations in GNS3 and then practice this SIm with Real Exam configuration for your Route Exam. You should then configure route summarization only to the distant office router R3 to complete the task after the problem has been solved. Your duty is to find and solve the connectivity failure problem with the remote office router R3. Presently PNG has configured EIGRP on all routers in the network R2, R3, and R4.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |